Cable directionality

BigTee,

Please don't confuse voltage with current. In order to drive your amplifiers to drive your speakers current must flow. The same thing happens in your AC line analogy. The cable shield issue that you are raising is real. Current will flow through the shield if the circuit driver and receiver are at a different reference potential.

Regards,

John

OK so interconnect shielding is grounded at one end only, hence the cable is "directional".
But I have seen "directional" speaker cable, and I cannot think of any possible explanation for this. Can anyone offer a plausible explanation?

John, But what if the shield is only connected at one end as some other folks are saying? Now, how does flow occur? I agree with the "Possibility" of potential on the ground circuit but I also know that electricity takes the path of least resistance (both voltage and amps---since volts do push amps.) You can see a ground wire (white wire---not the copper ground) spark at the breaker panel when it is connected to a load such as a motor but it has NO potential. Ground faults help with large, potentially dangerous shorts to ground as through your body. You are always going to have a difference in ground potential between a large amp drawing component and something less. You certainly cannot have voltage potential(and flow) without some sort of current, ever how small. No current, no flow.
So, I guess my question remains, since we are dealing with AC, how can wire be directional?

BigTee, you are confusing a "shield" with a "ground". They can be two different things. In some cables a "shield" is connected only at one end. There are still two other conductors to carry the signal. There is no mystery here to anyone who has ever worked in a calibration lab!

Sorry, but I can't help but be somewhat amused by this thread (and ones like it). I know next to nothing about electricity and circuits, so all I can do is humbly take note of the fact that no one yet in this discussion has claimed to have either heard the supposed difference flipping their cables around, or to have tried it and failed to hear a difference. Well, neither can I - I guess I just don't care enough to have bothered (and I'm quite willing to entertain notions of marketing-driven audiophilic excess here). But what I can say with certainty is that I haven't been able to learn anything for sure from all the confusion and contradiction above. Can it be that the engineering side of this hobby contains even less clarity and consensus than the listening side?