I forgot to mention that I have damped the motor, and I did this by getting 1/2 inch width lengths of "rope" elastic rubber from a rubber store,gluing a length together with a powerful rubber adhesive called "Loctite" making a ring.I then snugly fit one at the top and one at the bottom of the Rega motor avoiding the wiring.It is super quiet I cannot hear any noise and it did not effect the way the motor runs,I am right on speed at 331/3 rpm.There is another mod for the motor sold through English ebay.It is called the bearing mod and you drill a hole in the Rega motor bottom plate to fit a brass well in which sits a ball-bearing.The motor spindle the runs on tp of the ball-bearing yielding added stability and quietness and less wear.These are alternatives to getting the upgrade,you could try the rubber mod on the new motor though for added damping as it is now attached to the plinth,no harm in trying one ring around the bottom of the motor at least.You can make a rubber ring for the edge of the glass platter too.These are sold on English ebay as well.
Advantage of Rega Motor Upgrade
I am wondering if it would be worth my while to upgrade the motor on my Planar 2.This is for two reasons, I have tweaked the speed so my table now runs at 331/3 rpm and not fast like many Rega tables and I am using power condtioning which I believe would improve the speed stability.Am I going to notice that much of a difference with a P2/P3 upgrade and is there any real advantage over the old motor?
- ...
- 7 posts total
- 7 posts total