Speaker Wires on Carpet


I was reading that carpet will interfere with the signal going through speaker wires if the wires are on the carpet. I was wondering if the amount of interference varies depending on whether the positive and negative wires are twisted together versus running straight and parallel to each other. Also, will certain types of wire jackets cut down on interfence?

I ask this because I have wires running next to the base boards on the floor in my (carpeted) dining room since that's the most unobtrusive place for them. I may consider some type of wire elevators if they are reasonably priced and look nice.

Thanks in advance for any advice.
socprof
Rushton is right. Synthetic carpets are a dialectric! They WILL interfere with the electrical signal passing through the speaker cable. The better a speaker cable is shielded the less likely a listener is to notice a big improvement by raising the cables off of the floor, but even with my Purist Museaus, and later Venustus there was improvement.

None of this is idle speculation, it is common knowledge that synthetic fibers has dialectric properties that will affect the transmission of an electrical signal. If you don't believe it, leave your cables on the floor. If you raise them with something as simple as home-made wood tepees you will notice an improvement.
buy some tennis balls and put them underneath your speaker cables and listen then remove them and listen again you should clearly hear a difference
Ceramic cable hangers are available from Farm & Fleet or any other large hardware chain store ( Home Depot ) that has a good sized electrical department. A couple bucks a piece at most. Get the bigger ones, not the little ones. You won't need as many and even if the cables sag between them, which they will, the higher elevation probably won't let them touch the carpet, etc... Buying the same quantity of ceramic "audiophile approved" cable supports would cost hundreds of dollars rather than a few dozen dollars. Only drawback is that you've got to unscrew / remove the lag bolts that are threaded into the ceramic base of these. A little labor can save you hundreds of dollars. Sean
>

PS... If synthetic carpets can't store residual energy, why do people get shocked from a build up of static electricity arcing from their hand to a door knob or other metal objects??? As such, isn't it possible that the very high voltage level that is required to arc across non-conductive free air could also affect a conductor that already has voltage??? Wouldn't an equation like this be part of understanding basic principles of induction? Do the math regarding the conductivity of an inch of free air and that of a few millimeters of plastic, pvc, teflon, etc.. and then come back and talk to us. I'll give some of you a hint so that you can pass the test. You need to study a LOT more BEFORE raising your hand to volunteer answers.
Elevating cables is one of those things in audio according to most people's common sense shouldn't make a difference in sound quality but it does.
I would use speaker cable elevator on cable that does use much shielding.If your speaker cable is well shielded, and there are alot that arent, then u shouldnt worry to much about it. Talk to any seasoned guitarist. they dont want cheap cable running from their guitar to their amp. When playing on carpet the cable picks up static an amplifies it in the form a of audible crackle. They avoid this by good shielding cable. The same reasoning can be used with speaker cable. On stereos u wont hear this because the speaker cable isnt being dragged along the floor, like a guitarist would drag his phono cable around. But stationary speaker cable still will pick up some of that static. But if u dont have it laying on carpet, dont worry about it.