2. cables
  3. 1082506780

Speaker cable length for L/R channels critical?

I have a good system that utilizes some older discontinued speaker cable that I like a lot. It is 10 feet in length and I need that length to reach the left speaker. The amp is not (and cannot be) located center between the speakers.
The problem is I wish to biwire and have an opportunity to buy a 6 foot pair. The question is this: Can I run both 10 foot cables to the left speaker and run the 6 foot pair to right without any wierd effects like "ghosting" or have one channel be clearer or louder than the other? Any ideas? Thanx
ceb222
theaudiotweak
1,793 posts
 
Remember your brain/ears are resolute to time and phase response as well as frequency response.The more resolute the rest of your system is the more cable length will matter..It all is additive..Tom
eldartford
4,262 posts
 
Theaudiotweak...Not to belabor the point, but a 20KHz wave traveling at 916 Million ft/sec is 45,000 ft long (about 8.7 miles). Ten feet represents 0.000218 of a wavelength, and corresponds to a phase angle of 0.078 degrees.

My brain/ears are not that good!

This is an example of misapplied science so prevalent in audiophile circles. True, science says that there will definitely be a phasing discrepancy, but a very little bit of math (conveniently neglected) shows that it is completely inaudible.
theaudiotweak
1,793 posts
 
You cannot hear time and phase errors while your speakers swing free air like a pendulum. Tom
eldartford
4,262 posts
 
Theaudiotweak...Why not? Don't the instruments move around a lot while they are being played and recorded?
theaudiotweak
1,793 posts
 
El you have never heard your system.Tom
More to discover