Isolation Cones/Bearings placement on CD Transport

I second Stehno's post! Thats always been my understanding on placement too.

mostly what I use. My bearings device are not like yours since I use a DIY recipe ( Diyumas) but they basically do what other commercial devices do.

I would use one right under the spindle, where's more movement is taking place. The other vibrational point is the transformer.

BDiament, from Audio Asylum and maker of another devices, suggest an equilateral triangle and the most separate as posible position.

BUT..you should consider experimentation before deciding where to put them at the end. Make sure they are well balanced, the power cord doesn't make unneccesary preasure against the sides and the base where they will be seated are well balanced.

Thanks for all your replies. I will try the different placement options once I receive my Daruma Bearings. Since I have never used isolation devices before, I just wanted a general guideline before I actually tinker with them. I hope it turns out well.