Balance control vs. Speaker placement

Oh, one more thing. I for one would not vary the distance of the speakers to adjust the channel balance. My guess is although you may achieve better balance you probably introduce several other negatives to the sonic picture by doing this. This is just a gut thing and I have no scientific or engineering rationale to back it up, so take it for what it's worth. Personally I'd much rather fix the problem with room treatments or a balance control. Again, best of luck.

Tim

If room treatments won't solve the problem (or are impractical from an aesthetic standpoint), then it seems like the balance adjustment is your best bet.

I would NOT adjust the speaker placement in such a fashion that the speakers are unequal distances from your ears. This will introduce problems with arrival times that could be more un-nerving than a balance shift.

Finally, another trick you might experiment with is to adjust the toe-in on the right speaker. There was a speaker placement guide that I read (I think it was from Audio Physic - but it dealt with Psychoacoustics as a factor for speaker placement)...anyhow...it recommended adjusting toe-in on each speaker separately until you reach the optimal balance between soundstage and imaging. It also said that it would be normal to have one speaker toed-in more than the other.

-Dan

In my room, I measure the distance from each speaker to the exact center of the listening position to within about 1/8", and then fine-tune the exact distance by ear. That helps, as there's an optical illusion in my room that makes the right speaker look closer than it is.

In a previous room, I was getting the image pulled to one side despite all my careful measuring and wall treatments. By chance I found that a vertical cabinet edge well off to that side was the culprit. Sound was diffracting off the corner, which was acting as a secondary sound source. I would hang a little damping material on the cabinet when I listened, and the imaging was vastly improved (especially on close-miked vocals. I can't stand it when the sibilants come from a different point in space from the rest of the voice). You might have someting similar going on in your room - you might try draping a thick towel over various pieces of furniture to see if you can find the culprit.

Well assuming that doesn't help, I would suggest you use the balance control rather than positioning one speaker farther than the other, because you want to preserve the timing cues that would otherwise be skewed if you moved on speaker farther away.

I have moved the speaker to compensate for this and it works quite good. You only have to move it an inch or two so the side effects are small and better then an off center image. (at least to me) Ill also save you a ton of time and tell you that if the image in more on the right you adjust the left speaker and vice versa.

The alternative to a balance nob is a volume nob for each channel-slight mod.