GMA Europa owners, what amps do you use?


I am in the process of evaluating the Europas with a 45 Watt tube amp and a pair of solid state monos. After preliminary comparisons, I can see strengths of both approaches. I am wondering what other GMA owners are using to power their speakers.
128x128tcbannon
Roy, thank you for the additional information. BTW, here is an email sent to a colleague of mine from you (headers/info deleted.) I did not fully remember your earlier advice, and the question does make reference to medium listening levels, something you have posted publicly that Pete Whitley regularly exceeds:

>It has been so busy, I could not remember if I got back to you on this:

>>Could you please give me any opinions on integrated amps listing for under about 1,500? Since I rent, the size of my room may vary, but probably will be less than 20 x 20 x 8. I don't tend to listen much above medium volume levels. Many kinds of music.

>I wish I was more familiar with all the choices, but I think you would want at least 40Watts into eight Ohms for tubes and 60 for solid-state- you need the power for the brief peaks, and more power would be better, if you can keep the sound quality. I would check with our dealers listed below for amplifiers, as they try really hard to hear everything and not just stock what the magazines say is good.

>>Are there particular stands you like?

>No brand comes to mind- although Target has always been good. The stand height depends on your ear height AND your listening distance. See the first page of the attached owner's manual, an MSWord document, ok? The speakers are 8x10 on the bottom, and a top plate 6-7" wide, 8-9" deep would be appropriate. Use very small, 1/8-inch balls of BlueTac to keep mid-frequency resonances out of stands.

>Lastly, do you have a dealer list for eastern PA, southern NJ or NYC?

[snip]
Thanks for the email copy. I still stand by that advice- my answers above on Power are more explicit.

And Pete is not a wild man- he's just being Pete. There can only be one.
We all use up a lot more power, very quickly unfortunately, when we finally decide to play it LOUD, listening 15+ feet away.

If we just start to clip any amp, often we don't notice that at first, in some speakers because they are not clear (agile) enough. And in the Europas, in my opinion, this is because they don't "hold onto" an amp's clipping distortion- the actual onset of clipping is not magnified by them (its duration extended).
Any brief hardness/harshness from the amp remains brief because A) it does not trigger some particular cone resonance, etc. and B) because the time-coherent design keeps the packet of energy concise, if you will.

So then, if you don't hear what you think is clipping, it seems ok to take it up another full notch, to put the hammer down, because we say it's ok. But clipping any amp, or peak power levels exceeding 80W into 8 Ohms on compressed rock, means the tweeter will eventually go. Just like racing a sports car- new tires every race. About $30 for a re-tread here, per cab.

One can hear the clipping of course, if you know the recording and then take the loudness up very, very, very, very slowly, until you hear the amp just start to haze the image, then hear compress the depth, then finally rat-out the leading edges ever so slightly, but only on just one particular 'yelp' from the voice... sounds like a brief mic or mic-preamp overload (like an old doo-wop recording), except.. it goes away with a few dB decrease in the volume.

This is not the speaker distorting, because speakers, of any kind, seldom "clip" harshly- they just gradually compress the dynamics, then finally hard-limit (clip) in the woofer's stroke (or fuzz out at large excursions), or the tweeter finally blows up.

The gradual-compression effects in speakers are just that- gradual. They do not "go away" because you reduced that slowly-increased loudness by 3dB (half the power). Nor do you hear THE problem of image diffuseness, hardness on the voice, etc "come back" because you went back up by just one dB.

Hope I said that clearly- sorry if you have to re-read that. It's a linearity issue. Speakers and amps have different ways of leaving their linear behaviour regions. It's why an amp designer can tell the size of a power supply on just about any speaker at only modest SPLs. The departure from linearity he has trained himself to hear from a transformer is different that what speakers "always" do to the sound. He's also heard a lot of speakers.

So you miss the fact that the amp is starting to clip on rock, or loud R&B, etc. Because you don't care, because you don't know the recording that well yet. So you crank it on up one more full notch and leave it there- then the tweeters eventually die in the Europas, because you are near 100dB AVERAGE levels at 8 feet away. Which means pounding loud at that distance, yet merely "pretty darned loud" at fifteen feet, especially if the room is not a lively one.

It is always instructive to borrow a high-horsepower amplifier, even if you know it will be rougher-sounding than what you have, just so you know what happens from having the large power-supply capacity available on a moment's notice.

The Europas can handle peaks, briefly, to 120W into 8 Ohms, midband, like a snare drum whack, which at 8 feet away, is about twice as loud as most people think as being LOUD. Close to "my friends up on stage at 20 feet away- can't hear you right now!" loud.

Which in some societies is considered fun.

Best,
Roy
Anyone have suggestions for integrated amps that could be used to construct a more budget oriented system with the Europas? I've heard that some vintage SS integrateds can work well with these speakers.
Ok guys, here's a list of amps that were recommended to me for use with the Europas by an excellent source of information on this type of thing.

Recommended gear:

A properly re-built 17W/channel Dynaco SCA-35 integrated amp on e-bay. About 40 years old. (~$350 or so. They come up weekly- look for ones that have had "capacitors replaced and new diodes installed".)
The new Blue Circle integrated amplifier ($1100?).
Edge amplifiers (edgeamp.com ?) in Florida.
newest Plinius integrated.
Manley tube gear.
VAC tube gear.
Joe Curcio's website (can't remember)- Dynaco modifications.
Welbourne Labs in Denver (kits).
Birdland.com for DAC someday.
Audio Magic (audio-magic.com) for the finest cables etc I have heard, including their own DAC (expensive).
A used Tandberg integrated amp (Soundsmith.com I am pretty sure specializes in Tandberg).
A Kenwood KA-600 used integrated amp- silver, from the late 70's. Good luck finding one. Not a "601" or any other model number- just "KA-600" (or the smaller KA-500). They don't get on e-bay very often.
Croft amplifiers from England (tube, fairly $$)
Wavac brand tube amps (big $$ unfortunately)
Something our dealer in central California is carrying- an integrated I cannot remember, but I think $1500 (too much $$??) See attached dealer list for MotherlodeAudio.com
The Marantz PM7000 on e-bay- excellent. Also the PM-94 model.
The used Harmon/Kardon gear from the early to mid-1980's- typically champagne/light gold colored.
Used McIntosh tube gear on e-bay, and at Audio-classics.com
I am still waiting to purchase Europas, and am looking at a pair here. I recently purchased a Cayin 30/watt channel tube integrated, and love the sound. Since I listen from less than 8 feet, I am hoping it will suffice for the Europas.
OT, Roy, any word on when the "new" Europas will be available?
John