WHAT IS GOING ON WITH VPI ??

my responses are being edited to take out content. you can get my email address from my website or you can find bobsdevices on the dealer page of VPI in wilmington north carolina

I hoped a VPI expert might have a solution to my issue. I just upgraded my HW19 Mark II with a TNT Mark V platter and bearing. I think I have it pretty well sorted out except that after 20 minutes, the platter slows as evidenced by the pitch change. Any ideas of what might be causing this? I'd like to listen to more than one side per day!

Thanks,

Bob

Figured it out with the help of Larry at Hollywood Sounds. The pulley would heat up and then begin slipping on the spindle. Two drops of Superglue solved the problem. Highly recommend Larry!

Bob...I said the same thing here yesterday. Glad that Larry was able to help.

If putting some talcum powder on the belt doesn't help, please tell me the RPM of the motor you have...Is it 300 or 600?