New blood needs your Amp/system advice, please.


Greetings, Fellow Enthusiasts. This is my debut post on any sort of hi-fi forum. Excited to begin tapping into some of your knowledge/expertise.

I am slowly trying to piece together a clean, simple and very musical two channel experience. Cut my 'Seperates' teeth on a Rotel system about nine years ago... good entry level gear. My pre-amp recently died and I started a pupae phase of more critical listening and put together a few new pieces.

current system:

power plant: PS Audio PS-600

pre-amp: Audio Research LS3

cd: Naim CD5i

amp: Rotel RB 981 {120 wpc}

speakers: Paradigm Studio 100's V3.

speaker cables: Transparent "The Wave"

interconnects: Interlink "The Link" 200

The system sounds okay with vocals, guitar and horns etc. but is fairly flat and muddy in much of the mid-lower ends. It's seems obvious that these speakers are severely underpowered. Is this likely what I am hearing? What steps should I take to attain more balance in this system? How much power would be enough?

What Amps would you recommend?

Got a great deal on most of this gear and am still auditioning. Am not really married to any of it and am willing to consider replacing to gain a more musical enjoyment.

Thanks in advance for your time on this.

Cheers! Timothy
timtopper
I think you need to upgrade to a high current power amp,an older Krell perhaps.The speakers could stay for now,but you need a better amp.Your line stage is great,I got an ARC LS3B too paired with a Mark Levinson 27.5 in my second system,and it rocks,IMO.
Best of luck
George
Before blaming amp, place some DIY room treatment at first reflection points to see if that clears up muddiness & lower-mids. If DIY room treatment makes it better, later on you can add name-brand room treatment which is generally more effective & better-looking, but tres expensive.

Also, did system sound better with AR preamp. My feeling is system may need active preamp & may need the extra oomph not available with passive volume control or no preamp.
350W/C is not the answer. Experiment with placement. If that doesn`t work, look for new spkrs. Home audition seems mandatory in your case.

Just for laughs try some different interconnects I had monster m1000 and boomy bass which I always put down as room node changed to straight wire and problem was gone might work did for me
Bill