Peter, I didn't go quite far enough in my comments. I believe that in a subwoofered system, one needs to run the main system as full-range as it and you can stand. With your 988s, I believe you'd increase their power-handling capacity substantially merely by removing most of the low bass from their signal. That can be done with a 40- or 50Hz hi-pass filter point; I'd start with a 50. Then set the woofers' crossover points and levels wherever you want that SOUNDS good. The point is to keep your fine-sounding main system doing about 90% of the work, and sounding GREAT at it, of course, while increasing power-handling a bit AND adding lo-bass capability. The trick will be to find PLACES for the woofers to blend well with the main system.
I've done something similar in biamping my Eminent Technology 8s. Initially I duplicated ET's c. 40Hz MR hi-pass filter point with an active filter in the amps. I then eliminated the hi-pass filter and have been running the MR panels wide open. I THINK it sounds better. At least I've eliminated the sound of one cap and its inherent phase errors.
If those 'Cary EL34 triode amps' are Rocket 88s, their 150K-Ohm input impedance would create a 48Hz filter with a 0.022µF cap.
Good luck. Pls let us know what you do.
.
I've done something similar in biamping my Eminent Technology 8s. Initially I duplicated ET's c. 40Hz MR hi-pass filter point with an active filter in the amps. I then eliminated the hi-pass filter and have been running the MR panels wide open. I THINK it sounds better. At least I've eliminated the sound of one cap and its inherent phase errors.
If those 'Cary EL34 triode amps' are Rocket 88s, their 150K-Ohm input impedance would create a 48Hz filter with a 0.022µF cap.
Good luck. Pls let us know what you do.
.