Static electricty - Can it damage audio gear


I have run into a problem with static electricity and my AVP2 processor. It took a while to figure out but if I rub my foot on the carpet several times and touch the processor it will suddenly change into another mode or freeze into a setup mode. There is no shock or spark but the unit still freezes. Can this cause permanent damage to any of the circuitry ?

This is the 1 st time in 6 years that it has happened. Can a faulty component in the processor cause this problem ? Any suggestions

Thanks , Dave
dpetrenko
This issue always seems to come up on the forum during the winter months and yes, damage can occur to some sensitive circuits. Be careful as some audio companies can detect static charge damage on warranty claims and consider the damage to be an "act of God".

Just to be safe, do as the other members have suggested, where the easiest remedy is to discharge yourself by touching your metal rack or something metal nearby. Even touching the corner of a wall as the cornerbead is enough metal to disharge the energy.

In addition, and another simple remedy, is to make sure your shoes are off.
You might also consider getting one of these. They use these when building computers and other electronics to insure no static.

http://www.uline.com/Browse_Listing_1755.asp
with regards to treating carpet with anti-static stuff, would i need to treat all of the carpet in the room or just the area where i stand when adjusting my stereo? also, is there a good ratio of treatment:water to use when making the solution?

thanks
i did a little more digging and was able to answer my own questions. this thread over at audio asylum had some good info.