Tube amps and speaker ohms


In your opinion , do push pull amps work better with 8 ohms or 4 ohms. .I am under the impression the lower the ohms, the more power is demanded from the amp....Another question, are there low powered SET amps ,and high power SET amps?
I'm looking at a 40 watt 845 tube amp for my 8 ohm, 89 db speaker.. just cked the Thor has a 86 db W18 midwoofers(2 per cabinet) and a 88 db tweeter. Will an 845 amp rated 40 watts be able to drive the 86/88 db speaker? With authority, bass, mids, highs, in dynamic sound stage? Synergy? Or poor match?
bartokfan
05-29-07: Divad68
Sticking with floorstanders that have a healthy bass output and are not bright or overly forward sounding, can you suggest any manufacturers/models I should potentially be shortlisting?
The Castle Acoustics Howard S2 I just purchased fit your description like a glove.

Silverline Sonata III are another option.
David, the best advice I can give you is to talk to a few speaker builders/manufacturers. They will be able to give you very good advice. There a couple on the BB like Audiokinesis who I am sure will be happy to talk to you. A few others are omega, decware, coincident etc.

I have speakers rated at 88db/1watt/1mtr sensitivity that I drive to very loud levels with a 12wpc tube amp. The bass really pounds and I can measure it down to the mid 20’s (albeit at –10db). I can do that only because my speakers are very tube friendly. Some other poster mentioned his 200wpc amp is barely capable with 96db rated speakers – somewhat ridiculous no? If I hook up my 22wpc SET I can blast the doors down.

Regards
Paul
Dear Bartokfan: The speaker efficiency ( 86db,89db,etc )is not the only subject when you want to choose an amplifier, either the nominal speaker impedance ( 8 Ohms, 4 Ohms, etc, etc ) because what you need to know is not only the nominqal impedance but the electrical curve speaker impedance where you can " see " how low goes that impedance.

The other critical subject that you have to take in count is the output amplifier impedance that IMHO must be a low one: say below 0.1 Ohm.

Regards and enjoy the music.
Raul.
raul. i googled amplifier output impedance and got several hits. The info if over my understanding, but will try to work with the ideas. I grasp that quality of transformers is vital in tube design, especially when driving a devil of a speaker such as are the Seas Excel. The motor on these speakers causes havoc on most tube amps. I assume.
Lets see if this link loads:
http://www.transcendentsound.com/amplifier_output_impedance.htm