Please help Two amps to one pair of speaker?

I biwire from the tube amp to the speaker using spade connectors, and another biwire from solid state amp to the speaker using banana connectors.

If I use tube system for music, I will remove the banana connectors from speaker or remove the spade connectors from the speaker if I use solid state system for movie.

The problem is I have to plug and unplug at the speaker connections every time I change from music to movie.

My question is can I use just leave both sets of the speaker connectors on the speaker and use one amp at a time (the other amp must be off) without any problem?

What if both amps turn on with both set of speaker connectos on the speaker?

Thanks for your help!
Tran

Sooner or later you (or someone else) is going to turn on or leave on one of the amps when the second one is powered up. Boom!!!!!!!! You will probably lose one of the amps, maybe the speakers drivers.

I have two completely seperate sets of electronics with seperate cables from the amps connected to the speakers with banana plugs. Very easy to change the plugs at the speakers. No downside, except the cost of a 2d set of cables, but for your HT systems inexpensive cables should do well for you.

Not until the day both accidently get switched on together & you've destroyed one amp for sure, & have an excellent probability of damaging the other amp along w/ the spkrs. You either need a switch box or a pre amp/processor w/ a pass thru.

Thanks for all your helps. I probably go with pre-amp pass through or install another pair of in wall speakers.

You shouldn't do it even if one of the amps is off. You need to use an A/B switch. Or get a preamp with pass-thru.