Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
For some reason the last paragraph got edited this is how it should read.
For speaker cable, for my bass ACI SV12 IB 4cuft 25hz to 150hz I use 4 x 1mm solid core silver per phase.
Then for the ML ESL's 150hz to 20khz I use again 4 x 1mm solid core per phase 99.99% copper.

Cheers George
TelWire is solid core copper, the Mogami stranded copper. I made a set of speaker cables using 1 x copper solid core combined with 1 times silver solid core per run.
George: Forgive me but what I'm about to ask has been mentioned 100 times in this thread but I guess I just want some reassurance. I'm about to purchase a solid state amp with a 51,000 ohm input impedance and a .75V input sensitivity. My dac outputs 82 ohms and 2V. I'm also thinking about buying a TVC preamp while used, is still considerably more than your preamp. I listen to classical and jazz at moderate volume levels at most. Is the 51k of my next amp adequate, or borderline for my listening habits?

By the way, I'm a former LSA owner who was THRILLED during entire time of ownership. However, that was with an amplifier with almost a 400,000 ohm input impedance!
You will be fine with those specs. I have used the LSA with an amp with a slightly lower input impedance and the sound was just fine.