Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Should be no problems, try it on low first you should have enough seeing you have at the moment with it direct. Then if you need to push it harder try the 5v.
As for the impedance of 100kohm on the Krell this is great, as with the Lightspeed which mimics a 10k pot you'll have a combind Krell plus Lightspeed load impedance 9k which the 300ohm source output will see which should also be fine.

Cheers George
You should be just fine. Especially if you can drive the Krell direct from the Ayon.
Thankyou gentleman!, The main reason I am interested in the Lightspeed is running the Ayon direct versus having a pre-amp sounds to forward for my tast!, most people do not have this problem with the ayon 2s with a pre-amp!, To me, running the Ayon 2s exploits the true nature of this player, And I have to say, I hate a forward sound!, I was thinking that the Lightspeed would act like some sort of buffer to rid the forward sound, now, thats if the Lightspeed itself is not forward sounding!, where do I buy the Lightspeed?, How does it compete to the tvc?, witch do you guys think has the better sound?,, Thankyou, cheers!
You can buy the Lightspeed directly from George. Email him at georgehifi@optusnet.com.au. Also, check out this thread regarding a comparison I did between a few different passive/buffer units:

http://forum.audiogon.com/cgi-bin/fr.pl?aamps&1248137240&read&keyw&zzavc

http://forum.audiogon.com/cgi-bin/fr.pl?aamps&1286153678&read&keyw&zztruth
@ clio09, Thankyou, you are a gentleman!,You also proved to be a great asset here for me, I will take a look at the threads you posted here,again, Thankyou so much!