Using two channel amps as monos?


I'm considering using two identical two channel Edge M8m amps as monoblocks. Any thoughts or advice on this configuration would be greatly appreciated.
jeff_l
another option is to run them in a vertical biamp arangement, if your speakers accommodate it. This would give you all of the benefits you're after - separation, and power.
Jimjoyce25,

The immense advantage of monoblock running as Spectron does - you can run them FULLY balanced and thus:

"...balanced mode of operation doubles the slew rate and bandwidth by virtue of the out of phase transmission. This also suppresses the noise and buzz originated upstream from the amplifier. The other major advantage of mono balanced mode in Spectron amplifiers is that transmission of both positive and negative signals (in each amplifier) is maintained separately from the amplifier's input to the speakers binding posts. Assuming that the signal path electronics are matched, all of the intrinsic amplifier distortions arrive at the speakers with practically identical amplitude but with opposed polarity and essentially cancel each other. The result is a largely noise and distortion free sound transmission, leading to a spectacular improvement in three-dimensionality and resolution of detail in the music"

i.e. utilizing two channels, as Spectron does, you can run them with two sets of signals but opposed polarity and practically eliminate any distortion.

When you run only one channel you double your headroom which is immensely important but you keep the same distortions in signal path.

All The Best
Rafael
You might want to try the configuration I'm using in a second system. It has two Forte 3's run as monoblocks. I've been very happy with the results. The biggest improvements were in the channel separation and soundstage/depth. Note that I've not bridged the amps. My set up was done by removing the +/- fuses from one of the channels in each of the stereo amps. This way you will have a virtual monoblock consisting of a dedicated chassis, transformer and power supply for the remaining amp to use without sharing these resources as in a typical stereo amp configuration. If the topology of your amp does not share anything other than the PS you would be good to go.
Dob-----Are you by any chance an attorney? I noticed you didn't answer the question I posed: Have you actually done a comparison listening to the amps running in both modes? It would be interesting to hear from someone who has done this.

With the Sunfires, to run in mono-strapped mode, you need a single-ended cable input. My cables are balanced, so I can't do this, and I just run one channel through each amp. Hence, my interest in hearing from anyone who has actually done a comparison like this.
Hello Jimjoyce,

Double no - I am not attorney and I did not do this experiment. I can't comprehend that someone having two channels which he/she/it can use "free of charge" in fully balanced mode will choose volunterely to use only one channel.

Its almost like experiment: to run on one leg or to run using both legs...well,almost. - we all did this experiment.

All The Best
Rafael