Running a fan to cool amplifier any ill effects?


I have two mono blocks....VAC 140's and have installed whisper fans above the transformer(s) housing. The fans aren't directly blowing on the 8 300B tubes...but they will be running cooler as air will be circulating around them. I installed the fans because the metal housing would become hot(125deg+ I would guess)and I personaly would prefer to cool it down. Kevin Hayes says this is normal for that amp. Do tubes need the heat to perform better or is some cooling ok...and have no effect?? on the sound quality. I am looking for some informed opinions....any would be appreciated.

Also the air will not enter the vents so no dust will deposit inside the amplifiers.
wavetrader
Unless your amplifiers are in a confined area, you should not have to worry about heat. VAC designs their products with heat dissipation built in and normal air flow around the tubes will provide adequate cooling. Fans are not necessary and may introduce unwanted noise. I think you are fixing something that isn't broken.
Thanks for the responses so far....the fans are on a seperate cicuit than my audio equipment. I checked out the noise level...not a problem. I realise that the amplifiers are well designed units....the transformer housing which is thick heavy metal gets hot enough where I can only heep my hand there for about 3 seconds. So to me I just feel better if the cooling will disipate some of the heat generated. If it extends the life of the tubes....even better...though it might seem unnecessary or overkill.
Try to prevent the fans from touching the chassis .
The fans could induce a low level vibration and a subsonic that the Amp will carry. Perhaps making your amp work harder.
If you can, put the fans on a stand blowing on the Amp.
I have two mono blocks that are fan cooled. Because the design was for rack mounting, and the close proximity of the 8 el34's per amp, this was a must. The fans blow directly across the tubes. The original fans were ac driving, and I replaced them with very quiet dc driven types with their own supply system. Each fan is on a rubber mounting system to help isolate their vibration(which is minimal)from the chassis. I believe that this prolongs the life not only of the tubes, but other components inside the chassis. These amps are now 45 years old! I believe if you check around, you will find that most "experts" will tell you that excess heat will age a tube about as fast as anything(ok over biased etc). Some complain of the noise, but I have been able to screen this and slow the fans such that it doesn't bother me........
My amp has 12 6550's in it and while the tube cage doesn't get hot to the touch, I cool it down with an external fan. In between playings of an hour or so, I will just cool the amp down for a minute or so and than continue to listen to more music. Once I shut down the amp, I also cool it again until the there is no heat at all emanating from the amp. I have an open rack which makes this procedure easy. I have experienced no ill effects from this and if it does extend the life of the tubes, that's a bonus.