Are There Any Good, High Power Solid State Amps?

When I owned the VR4 Gen III HSE, I owned or auditioned the following amps: VAC Phi 110/110, Channel Islands Audio D100 and D200, McCormack DNA-2 Platinum, McCormack DNA-500, Nuforce Reference 8, Odyssey Stratos Extreme Monoblocks, Moscode 401HR, and a few others that I've forgotten.

The Moscode 401HR and VAC Phi110/110 were a level above the rest. The Moscode had better bass control and bass extension and was less fussy about matching components. The VAC Phi 110/110 had the magical VAC midrange and overall clarity. It was a little fussy about the electronics in front of it, regardless of their excellence, and it could sound a little bright at times...a quality that I was always fighting with the VR4 Gen III HSE. The Moscode was extended and did not produce brightness in the speakers.

I was reading a glowing, 6 Moons review of Bryston 28B's. Doesn't seem to be your typical Bryston and is the basis for the next generation SST^2 series. Looks like they go for abut $8k used.

Here's another suggestion Louis.
Keep your 100 watt tube amp and add 2 self-powered subwoofers like the Vandersteen 2Wq with their high-pass filter. This will relieve your amp from the power-sucking bass frequencies and add 600 watts of power for the 20Hz-80Hz subs. You will find the headroom of your existing amp increase enormously as well as the performance of your existing speakers. Here is a link to The Audio Perfectionist and what Richard Hardesty says about the Vandersteens.http://www.audioperfectionist.com/pages/freejournals.html Click on 'Download Revised Journal #2 Free' and then scroll down several pages till you get to SubWoofers.
Only subs with a high-pass filter will allow your existing amp to gain headroom.

McIntosh MC402...no?

Having owned VR4 Gen III HSE, I believe adding subwoofers would be unnecessary and a mistake.

Buy an amp that drives them properly and you're going to be very happy.