2. amps-preamps
  3. 1273430950

Zu speakers with Atma-Sphere M60 amplifiers

I own the latest version of the Atma-Sphere M60 amplifiers. Arriving soon are a pair of Zu Definition speakers. Does anyone here have any experience driving the Definitions with the Atma-Sphere M60 amps. Observations are most welcome. I am given to understand the Definitions are approximately 6 ohms. I'm hopeful this will still work satisfactorily.
frontier1
tvad
9,467 posts
 
IMO, M-60 amps are overkill for the Definitions. An S30 would do the job.

However, if you specifically want monoblocks, the M-60 amps can be run lower power with only six or four tubes per chassis.
tpreaves's avatar
tpreaves
2,515 posts
 
No disrespect but,shouldn't you have researched this before buying?Just a thought.Good luck.
audiofeil
4,011 posts
 
You can safely remove output tubes from each amplifier to reduce power output and heat.

Good luck.

Dealer disclaimer.
mrderrick
291 posts
 
If you have to much gain (very little volume control) you can also replace V2 with a jumper plug to lower the amps gain. I run Avantgarde Duo Omegas with M60s with only 4 tubes per amp and V2 jumper-ed out. Atma-Sphere can set you up with a pair of plugs or you can DIY them if needed.
keithr
950 posts
 
you might ask Zu (Sean) to make sure the impedance is correct for OTLs---as I recall, you can have this adjusted at the factory.
More to discover