Manley Snapper vs Neo-Classic 250


I'm wondering if anyone has any opinions/experience/thoughts on the sound differences between these 2 amps.
gwng8
As a quick FYI, you can have a triode/ultralinear switch added to the Snappers when ordered.

***Manley dealer disclaimer***
Disclosure: We are an authorized Manley Labs Dealer.

Just thought I'd chime in on the discussion to add a consideration. The Neo-Classic 250s are clearly wonderful amps and will provide more than enough power for all but the most difficult loads. That said, the selection of your next set of speakers is very critical to your amplifier choice. Although important, be careful not to get too caught up with speaker sensitivity. Do pay very close attention to the speaker's full range impedance. Manufacturers typically report an average and this can get you into trouble with many tube amps. Look for a very flat impedance (i.e. easy to drive load). B&W is a prime example in many of their models, as their impedance is reported in the 4 to 6 ohm range, but upper bass frequencies can dip significantly. Your dealer should be able to clearly qualify his options given your amp choice.

On a separate topic discussed, please note that the Snappers can also be ordered with switchable triode/Ultralinear modes for a modest fee. We use dual mode Snappers in our store. They are also wonderful amps with the right speaker choice.

Hope this helps! Please support your local dealer.
True. That extra money could support other purchases to improve the listening experience.

What speakers are on your list for audition?
^ I have a long list to par down:
Dynaudio
Monitor Audio
Reference 3A
PSB
PMC
Epos
Elac
Accoustic Energy
Living Voice
Tannoy
I've also always liked MBL...but pricey


I'll check on the extra cost to add the triode switch to the Snappers....might help close the price gap
The cost to add the dual switch to the snapper is $300...so that is a nice option to have. How much heat do either of these amps put off? Would putting either one on a shelf with about 16" of clearance to the one above be an issue?