i am NO techie...i would be very surprised if you had any damage at all. your speaker was just on...no signal coming in and no requirement to drive a load. i hope i am not wrong...but i suspect this is no big deal. it just sat there on.
Leben CS300 tube amplifer without load / speakers
I was doing some cable rolling on my system and removed the speakers cable from my Leben CS300 to plug the cables to another amplifier. Then I switched the Leben on for a while to warm it up....but forgot to plug the speaker cables again.... what an @#$^$% (repeated 1000x)
I left the Leben for approx. 60-90 min without the speaker cables plugged back. Positively there was no signal going to the Leben.
1.Should I expect any damages to the trafos or any other parts?
2.Any damage on the tubes?
3.Does the Leben has a protective circuit when no load is applied?
4. How can I check the internal damages?
FYI, it is soundwise ok, I didn't notice any impact on sound quality.
Please reassure-me (or make fun of me), I had too much sleepless nights already
I left the Leben for approx. 60-90 min without the speaker cables plugged back. Positively there was no signal going to the Leben.
1.Should I expect any damages to the trafos or any other parts?
2.Any damage on the tubes?
3.Does the Leben has a protective circuit when no load is applied?
4. How can I check the internal damages?
FYI, it is soundwise ok, I didn't notice any impact on sound quality.
Please reassure-me (or make fun of me), I had too much sleepless nights already
- ...
- 6 posts total
- 6 posts total