1. Home
  2. amps-preamps
  3. 1362625994

Can You Get 1,000 WPC Out Of Regular Wall Socket?

.
I see the new Emotiva (100 lbs) and Boulder (450 lbs!!) 1,000 WPC monoblocs require a dedicated 20 amp circuit per monobloc.

I recently read where someone had his Krell 750mcx monobocs changed from 110 to 220 because he said they sounded better.

Well, the D-sonic digital amp weighs 20 pounds and is rated at 1500 WPC. Can an amp pull 1500 WPC from a regular household wall socket?
.
mitch4t
almarg's avatar
almarg
8,673 posts
 
Thanks, Kijanki. Excellent response, as usual.

So it sounds like there are grounds for cautious optimism.

One point to note, in relation to AC current requirements: Although the subject line of the thread refers to 1000WPC, the amplifier in question is a monoblock rated at 1500W.

Best regards,
-- Al
mapman's avatar
mapman
15,679 posts
 
BEst case scenario for the D-Sonics might be similar to what I observe with my mere 500w/ch rated BCs, ie it sucks the power from the line when you turn it on without issue then is powered up and ready to go with relative little strain on the external power line from there.
mapman's avatar
mapman
15,679 posts
 
BTW, in EE or signal processing,terminology as I understand it (as opposed to digital computing), my references to "bandwidth" above would probably be more accurately termed "dynamic headroom".
swanny76109
380 posts
 
Bel Canto Ref 1000M is not rated below 2 ohm impedances. And they do better with higher impedances, 4 or above, for the least distortion. The online Stereophile review with John Atkinson's follow up tests will show the specs and test results. This cannot be extrapolated to other Class D designs, of course. They are fabulous amps though with the right speakers.
mitch4t's avatar
mitch4t OP
1,486 posts
 
.
Map, Al, Kijanki, Swanny, et al.....a big thank you to all of you for chiming in on this issue. I really appreciate your contributions.

Jeez what did audiophiles do for answers before the internet??

mitch
.
More to discover