SL1200 upgrade tonearm or replace cartridge?


The upgrade bug has started to bite again. I'm thinking of upgrading my tonearm from a stock sl1200 tone arm with cards wires to a SME arm (309, IV, or V).

My other issue is that my cartridge, a Benz Glider homc, I nearing the point where it could use a re-tip or exchange.

My budget is limited, so I can only do one of the above this year.

So my question is, which upgrade cart or arm?

Is the glider a good fit for the SME arms?

Which SME arm is the best fit for the SL1200?
nick_sr
I had a SL1200 and felt the same way about the tonearm. I bought an adapter for the TT to put a Rega RB300 that I owned on it. It was a real improvement.

I ended up putting the table back to stock and selling it. I just never bonded with that TT. But to my ear it sound much improved with the Rega TA installed.

http://www.soundsupports.com/page16.htm

http://www.audiokarma.org/forums/showthread.php?t=324755
Ok, is all of this really necessary? I run my SL1210M5G bone stock, and I'm very happy with it. It sounds superb to me. That's my take.
Johnny it's nice to finally see pics of your TT and all it's upgrades. Looks great, I bet it sounds great too!

On a side note, earlier this week two tubes of my phono section died. Two Psvane 12ax7s that were less than 2 years old. Needless to say I am totally Pvissed! I replaced them with some EH tubes. Now the system is really sounding much better and the tubes still need some break in time.

So maybe my itch to upgrade was caused by the dying tubes! Then again maybe not.

Since i began researching my options in more depth, I am starting to like the idea of simply changing the arm wand, as shown in one of the links posted by Vegasears.

I figure the worst that can happen is that I scrap the stock arm. Then I will be forced to upgrade! And I may learn something in the process.

One other factor is that I just heard that Benz has stopped producing cartridges, this maybe my last chance to get a new Glider. Needledoctor has removed prices from their site and replaced them with a note "please call for prices and availability".
Can I mount a ten inch arm on the technics SL1200? The stock arm is 230 mm (9").