Cable Length Query


I am installing a new primary SS amplifier. If I set this unit between the speakers I will need 4 meter XLR cables but the speaker cables will be 2 meters. If I put them amp in my wall enclosure, the XLR will be 1.5 meter but the speaker wires will need to be 6 meter.

Which would be the better option? Any assistance would greatly be appreciated.
128x128mm1701d
Thanks, Elizabeth. Emerson (Foster_9), can you describe the speaker cables more specifically, including what gauge they are? And are they a specific make and model, or just generic two-conductor hookup wire?

Best,
-- Al
Emerson, yes the JW Audio Cryo Nova is described as AWG 12, consisting of two solid core conductors twisted together. A 15 foot length of that cable is reasonable in terms of resistance and inductance, relative to the impedance characteristics of your speakers. And I would feel safe in assuming that the capacitance of the cable would be no problem for any reasonably designed amplifier.

Given that, IMO all that can be said with certainty is that whatever sonic effects the cables may have will be greater than if the length were shorter, essentially in proportion to the length difference. Beyond that it comes down to speculation. My speculation is that compared to say a 6 foot length of the same cable, the differences are not likely to be great enough to warrant concern.

Best,
-- Al
Wow, thanks everyone for the information. I have a SIM Audio Preamp and just purchased a Krell KSA250. Like Elizabeth, I have built into the left wall a custom equipment enclosure. However, the Krell is too deep to fit into this rack. Coupled with the weight, I plan to set it between my Martin Logan Ethos speakers. From the back of the rack to the center of the wall would require a set of 4 or 5 meter XLRs. This is the first time I have had the opportunity to have balanced cables.
Marcus
Sounds like an excellent plan, Marcus.

The Sim Audio preamps appear to all have low output impedances (e.g., 50 or 100 ohms).

You will be using balanced interconnects.

The impedance of the Ethos speakers descends to very low values at high frequencies (in this case 0.8 ohms at 20 kHz), as is typical of electrostatics. Assuming that the goal is for the speaker cables to behave in as neutral a manner as possible, that makes minimization of their inductance an especially important factor. Inductance is proportional to length, for a given cable type.

For a 2 meter cable length, I would expect the great majority of good quality (not necessarily expensive) speaker cable types to have adequately low inductance per unit length for use with your speakers.

It all adds up to long interconnects/short speaker cables being the right approach in your situation.

Regards,
-- Al