Speaker's efficiency, sensitivity and impedance

Chris, thanks - hope that was somewhat helpful.

Gregm, you are of course correct - the proper expression of efficiency would be a percentage, and then we could probably do apples-to-apples comparisons! I've only seen percentages given in prosound, though. Note that I used the wording "as commonly used in consumer audio" so that I could go back and weasel my way out if necessary, and I'm invoking that weasel clause now.

Duke

So, what would be easier to drive?
A speaker with 90DB and 4 ohms or a speaker with 88DB and 8 ohms?

YES- semantic gymnastics seems the most popular sport in the audio industry, and these forums. You can see by the definition for "sensitivity/efficiency" given by a company some of you MAY be familiar with(after all the years they've been manufacturing for the sound industry), that even JBL considers the two terms synonymous- second question on this site: (http://www.jbl.com/home/product_support/JBL_contactus.aspx). The difference between the two terms lies in the input being measured in volts for sensitivity, and watts for efficiency(as mentioned), and that depends on the semantic application that the manufacturer or rater chooses to observe. Another professional view: (http://www.projectsunlimited.com/audioProducts/MovieClips/TechNotes/Glossary.asp?articalID=29) This site offers a caveat regarding the use of 2.83v as a reference, and how the result's affected by a system's impedance: (http://www.transcendentsound.com/amp_input_sensitivity_and_gain.htm) So much obfuscation found in here!

06-26-08: Jeffjarvis
So, what would be easier to drive?
A speaker with 90DB and 4 ohms or a speaker with 88DB and 8 ohms?

The two speakers in your example don't differ a great deal assuming their impedance curves are similar. If one has a flatter impedance curve, then that one would be more successfully driven by a larger selection of amplifiers.

The 90dB speaker would require slightly less power to produce the same output level as the 88dB speaker in the same room.

If the 4 ohm speaker had a flat impedance curve, it could be driven successfully by a good PP tube amp (balance meaning an even frequency output from bass through treble without one are being more prominent than the other). If the 8 ohm speaker had a flat impedance curve, it'd be a better candidate for a tube amp. If the impedance curves have large dips and peaks, the speakers will be more successfully driven by a solid state amp that doubles power output as impedance is halved.

Frequency imbalance as a result of large, varying impedance curves combined with the wrong amplifier is a primary cause of speakers sounding "tipped up" with high frequencies sounding more prominent than bass frequencies.

So, the answer to which of the two speakers is easier to drive depends on several factors: impedance curve, room size, type of amplifier being used.

IMO.

Jeff- View the last site(URL) in my last post. There's a brief treatise on how impedance, amp output and sensitivity affect a system's SPL(just past the halfway point of the article).