Preamp inverts phase question:

Al, I switched the cables at the speaker end. The cables I was using at the time were shielded. Doug Blackburn's contention was that the cable-switching affected signal flow directionality of wire and other devices (capacitors, etc.) inside the speakers (soundstage.com/maxdb/maxdb101999.htm) if i understand him correctly. Further, he questions the audibility of polarity-switching per se.

Needless to say, self-proclaimed polarity guru Clark Johnsen ("The Wood Effect") opposes Blackburn's views, to put it mildly. I'm honestly not sure who's right. I only know what I think I hear, and fortunately it's repeatable.

Thanks for the 6moons article. Very interesting. Dave

Will the mono setting on my preamp help me in any way to determine correct phase via listening tests?

Will the mono setting on my preamp help me in any way to determine correct phase via listening tests?

Well, maybe a little bit, by cancelling out the stereo information and simplifying the sounds you are listening to.

As you probably realize, the mono switch makes for a very convenient way of checking relative phase (that the two channels are in phase with each other). In mono mode if relative phase is correct a sharply focused image will be heard centered between the speakers, and if it is incorrect an unfocused diffuse image will be heard.

But I would expect the relevance of the mono switch to assessing absolute phase/polarity to be subtle at most.

Regards,
-- Al

You can hear if the system phase is inverted at the XLR by pin configuration or the preamp my design is phase inverted, and tube preamps have a history of this and the manufacture notes that in the owner manual.

My dealer told me never to switch the + & - at the speakers, always at the amp. I have tried it both ways and you can hear a huge difference, I use Dynaudio Confidence 5's.

Switch and the speakers and the sound will thin out and lose some impact and dynamics, switch at the amp and body and the bass dynamics come back.

I get more results than using the polarity switch on my cd player. Bound for Sound wrote about this 20 years also.

This has nothing to do if the CD is recorded properly. We start with the system then check your LP or CD if imaging is poor, and bass is not tight with impact.

This is not even hard to hear if you go to live concerts and train your ear. Perhaps some system will not show it as much, but my speakers have no problem letting me know something is a miss.

I think that the original question should be re-posted and all those who participated in this thread be barred from answering.