PS Audio P3 power Plant

You have to be crazy to connect a Class "A" amp to a PS Audio power regenerator.
Sorry to say the PS system basically is another amplifier putting out 60 Hz high amperage power.
It is a hard load to connect it to a class "A" amplifier.. even a low wattage one.
The PS Audio regenerators waste about 50% or more of the power they use.. So to a Class "A" amp it is really going to burn through energy..

I use my PS Audio P600 only for my digital stuff. That way it is just idling along. instead of being forced to output it's maximum power all the time.
The electricity wasted alone will raise your room temp 10F..
So I would suggest some other conditioner type for your amp.
KEEP the PS for everything else if you like it, but find some other item for your amp. NOT a power regenerator.

I would suggest a Furman
I use a Furman REF20i I bought used here.. For my amps and all the analog stuff, and my video.

Elizabeth,
I live in India and power quality that we get from Company is quite bad. In that case I thought, would a Regenerated power from PS Audio P3 not be a better supply got my Amp ? I am ready to live with higher energy consumption or temp rise for that matter. But at least my Amp will get pure sine wave power !

Realize the PS Audio power regenerators like yours improve the sine wave, but they do not make a perfect sinewave output. They improve it, but really still leave some irregularites in the power wave.
Like my PS Audio P600: if the incoming power has 8% grunge, then the output will be about 2% grunge.
Less.. but not perfect.
Also the PS Audio or any power conditioner really work best at well below the rated total power output. The greater the output, the less perfect it is going to be.

You can try your amp on the PS Audio P3, but watch if the P3 runs much hotter..If the P3 does not seem to be running too hot then it may be fine.

I had a PS Audio PPP and found it got too noisy and hot just from running my plasma TV! So I sold it and found the Furman which can handle much greater loads.

The P3 has two 'high current' outlets that are filtered and surge protected but draw their juice from the house AC - they do not draw power from the regeneration part of the P3. The 750 AV limit of the P3 is not affected by anything plugged into those two outlets. There is plenty of power for all the front-end pieces you want and it looks like your amp as well.

If you want to be sure, go to their site and find the email address for their sales dept (under Contact Us). I sent them some questions and they answered within an hour or so.

I picked up a used PS Audio Premier Power Plant for my system. I plug everything into it except my power amps, JC1 Halos. They plug right into dedicated lines, and the factory says to run them this way. The odd thing for me was the need to run my phono preamp, JC3, into the wall as well, and with the ground lifted. Everything is silent and the improvements in dynamics and image have made me feel these power regenerators are a fundamental part of a serious system. In fact, I bought a second and use it for my home theater. The plasma TV looks much better, and the surround sound system is much more vivid. PS Audio has a big listening room with four dedicated lines and their top regenerators on each one! Must be nice to play at that level!