20 amp dedicated lines


Id like to get opinions of those who have installed 20 amp dedicated lines. Did you notice a huge improvement, little or no improvement with the addition of 20 amp lines? My system is very lean with ill defined bass. I have tried everything I can think of to cure this problem with the exception of installing 20 amp lines. System consists of:
Wadia 861
Supratek Chennin pre
Parasound JC 1s
Vandersteen 3A sigs
Vandersteen 2Wq subs (2)
Alphacore MI2 spk cable (35' run)
Audioquest Cheetah inter
Cardas Golden Cross inter
GIK wall treatment behind spks, 1st and 2nd reflection, corners.

Its funny Vandersteen speakers are not known for being bright but my system is extremely bright and lean in the bass. I love the detail and spaciousness the Cheetah brings to the table but the sound becomes very unmusical. I have tried all speaker locations Q settings, level adjustments, x over settings etc...... Im thinking maybee the JC 1s are not getting enough juice. Any help much appreciated

Thanks
braro
I think the only way to find and solve your problem is to do some process of elimination things, first I'd move the amps close to the speakers and try some Rat Shack 12 gauge speaker wire just to see if thoses 35' wires are causing problems, next I would do some more speaker positioning and adjust cross overs, and the Home Depot cords are a good idea too. All these things will cost next to nothing and a bit of your time. I would spend some time on speaker placement and cross over adjustments as this can be one of the most PITA things to get right!
My two dedicated 20 amp lines, with FIM-880 outlets, did improve the bass. My friend the electrician, not an audiophile, even noticed it.

However, I don't think electrical is your problem. I recently had a similar condition, i.e., lean sound with a lack of bass, that was caused by the two 12ax7 Mullard gain tubes in my phono preamp subtly degrading over time (one year) until it became so pronounced I inquired about it.

I never would have guessed it was the tubes. I had two Electro-Harmonix 12ax7's on hand and swapped them into the phono preamp. Musical nirvana! I had no idea how far the sound had degraded until then. Everything came back, the meat and body of the music, the soundstage even improved.

I also found another audiophile who routinely changes the tubes in his preamp for the same problem. Perhaps the Mullards both went bad in a subtle manner and the EH tubes won't. I know I'll be aware of this, and swap out tubes just to check them in about a year.
In the package that came with the vandersteens he cautions the buyer from using long runs of speaker cable.He says that a moderate priced speaker cable in short runs will sound better than expensive long runs. He says use longer interconnects up to 2m. Do you have the Cheetahs running from the pre to amp or the Golden Cross. I have the golden cross and it is warm not bright at all.
I installed a couple of 20A dedicated lines and did not hear a significant improvement; maybe a blacker background. Having said that I would definetly suggest you install them but I don't think you will get the results your looking for. As others have suggested you might try some active line conditioning.
Yes I noticed a huge improvement! The lights don't dim in the room when turn on my amp. I had to many devices on the branch circurt. I have not notice any improvement in the sound.