2. misc-audio
  3. 1150117783

Behringer DEQ 2496 help

Does anybody know where in the menu I'd find an input gain/attenuation control? I've run optical out of my DVD player into the DEQ then analog out to my Harmon Kardon AVR7200 which I am using as a pre. I am trying to utilize the DACs in the DEQ, the way it is hooked up now I am getting a fairly high signal with the clip lights flashing on the DEQ once in a while. It does sound much better and I don't hear anything out of the ordinary when the signal clips. Is it OK to run like this or am I missing something? Any suggestions would be great, thanks in advance!
nuguy
cwlondon
1,198 posts
 
Where is the "max" switch?
eldartford
4,262 posts
 
Cwlondon...See page 14 of manual. Paragraph 3.8..RTA menu.
cwlondon
1,198 posts
 
Eldartford

I may have to give you my CC details for the ongoing tech support.

I had tweaked an EQ curve from the RTA which sounded really good, but unfortunately lost it when I couldnt quite figure out the memory function.

In the meantime, I think I also screwed up some other settings.

So back to the drawing board -- is there a quick procedure for a full factory reset?

Thank you.
eldartford
4,262 posts
 
Cwlondon...There is usually a way to restore factory settings, but I can't find one for the DEQ2496.
ecruz
402 posts
 
There is a way to reset to factory settings, I've used it before. But I'm at work right now & can't remember it. I think I found it by emailing Behringer support.
More to discover