dill
Responses from dill
| switching from isolated ground receptacle No, the isolated ground duplex receptacle is internally configured to isolate the ground. Just attach the white & black wires to the correct sides and put the bare or green wire to the ground post of the outlet. | |
| pass or krell PASS!!!! | |
| Isolation for Home Theater Speakers Get some Blu-Tack, that will cure the dancing. http://en.wikipedia.org/wiki/Blu-tack | |
| re-terminate nordost cables...anyone? They have a termination service. www.moon-audio.com | |
| Outdoor FM Antenna question I am very happy with my FanFare FM-2G. | |
| Used speakers: Cleaning tips? What is dealer dust? Is it different from customer dust? | |
| BNC to RCA adaptor I have a gold plated version, of the adapter, if you are interested. I can send you photos if you provide me an email address. | |
| Jolida JD-9A Phono Stage Hum Problem Well, all the ground wires end at a bolt in the middle of the bottom of the chassis. I took the nut off and removed the "O" lugs and found that there was only a small amount of powder coating removed and the bare metal had some surface rust. I rem... | |
| Jolida JD-9A Phono Stage Hum Problem Thanks for your responses. I am in the USA and it is not ambient, amplified thru the speakers. I have tried weighting the top of the unit and surrounding the case with metal, nothing stops the hum but my bare hand grasp. As I recall, the (4) trans... | |
| how to use gain control on a preamp If memory serves, I set the left/right gain so that the normal listening range of the volume knob falls in the 10:00 to 2:00 position. | |
| Sub connection Run the speaker wires from your amp to the speaker inputs of the sub. Now run a new pair of wires to your speakers from the sub's speaker outputs. Use the crossover & volume controls to match your speakers. | |
| Phono Stage Hum Might be the nature of the beast. I have the 9A and also have a low level hum. It is not audible unless it is very quiet or I put my ear to the woofers. I have tried all the suggestions mentioned above with no luck. Play with your cartridge settin... | |
| Question for Jolida JD9A owners The JD9A has plenty of gain and is adjustable, you will not have problem. As to the Rotel, 70dB/75dB is lots of gain, could be too much for a HO MC ... as long as it sounds good as doesn't produce too much noise, it is fine. | |
| Speaker Packing? The antique radio collectors use Greyhound to ship the consoles, very reasonably priced and they only get handled when changing buses, As long as they fit through the cargo doors. The downside is you need to drop them off at a Greyhound station an... | |
| VPI ARMBOARDS??? It is my understanding that VPI no longer supports the HW-19 series. |