gvoth
Responses from gvoth
| Well Tempered Simplex arm and wiring mr_m, can you measure the outer diameter and height of your silicon pot? Perhaps stick a toothpick inside and mark it to then measure the inner height? The connector has proved hard one to find... anything written on male part of the connector? A ... | |
| Well Tempered Simplex arm and wiring I'm getting close to similar performance to my ear. I can also change the length of my longer arm, which has come in handy. The first arm sounds fantastic on my Braun PCS-5 idler. That Braun's been a fun project... the it has a 50 hz pulley but it... | |
| Well Tempered Simplex arm and wiring Actually, both of my arms are there at the bottom, scroll down. | |
| Well Tempered Simplex arm and wiring You can see one of my clones on my Neat Shield MO-19 here at the bottom of the pagehttp://www.lencoheaven.net/forum/index.php?topic=12923.45 | |
| Well Tempered bearing old vs new As a test, I switched the black platter and larger spindle from my WTT with the smaller spindle and acrylic platter from the WTRP, leaving the bearings in their respective plinths. The black platter and larger spindle ride properly on the WTRP bea... | |
| Should I keep my Well tempered tonearm? Take a look around the web for interviews with Firebaugh. I couldn't quote him exactly (which is why I said 'somewhat'), but he has noted that many of the protractors we depend on do not conform with his WT protractor positions and this gives a cl... | |
| Should I keep my Well tempered tonearm? I have had a Well Tempered Turntable since 1990 - now sporting the clamp and LP Labs arm - adapted a WT arm tube to Simplex esthetic with golf ball, grommet, etc, built another clone of the arm and just bought a WTRP off eBay being sold for parts ... | |
| Should I keep my Well tempered tonearm? On the original black arm with calipers, there is a nylon set screw that is accessed from the rear of the table, behind the black azimuth knob. On my WTT, this screw needed replacement after the azimuth began wandering often. Once replaced, the az... | |
| Feelings on the Music Hall MMF 7.1 Can anyone tell me the diameter of the 7.1 motor and its height to where the belt hits the platter? Can you use a thread belt with it? Is the belt round? I'm looking for a Well Tempered Record Player round motor but may have to settle for somethin... | |
| Should I keep my Well tempered tonearm? You perhaps need to replace your set screw my azimuth also wavered until I got a replacement from Mike Pranka at Dynavector. He has a small cache of original WT small parts. Great guy. | |
| Should I keep my Well tempered tonearm? Try STP with the WT arm I've used it for almost 20 years.Bill Firebaugh says the arm already has some anti-skate built in so I always set my original WTT arm to zero. Even with my LP Labs Carbon Fiber arm upgrade, its Discovery cable wires are mo... | |
| How Many Turntables Have You Owned AR XA, Lenco L-85, Harmon Kardon ST-7 and currently a Well Tempered Turntable with quite a few mods. |