sdcampbell
Responses from sdcampbell
| Good automatic TT's If you can find a Thorens TD126 Mk3 in good condition, it's a very good turntable. It's not fully automatic, instead having a mechanism that lifts the tonearm at the end of the LP. I had a TD126 M3 for about 5 years in the mid-to-late 1980's, and ... | |
| If you couldn't get Vandersteen speaker's Dbx:I don't mean to be discouraging, but putting ANY speaker in that small space between your entertainment center and the left side wall MAY be problematical. The distance between the speaker and the rear wall will be sufficient, since the front ... | |
| McCormack or Quicksilver for Vandersteen 2ci? As Bigkidz notes, tube amps often have nice mid-range, but may lack bass control. Since you already have a tube preamp, I'd recommend using a SS amp with the Vandy speakers. My first set of Vandersteen speakers was the Model 2Ci, and like all Vand... | |
| great little speakers My favorite small speaker for many years has been the Pyramid MET-7, designed and made by Richard Sequerra, one of the audio "greats". I took them with me when I was teaching in the Far East, and really enjoyed their excellent performance in small... | |
| Room Placement on Vandersteen 3A Sig's? You would certainly have enough room between the rear wall and the back of the 3A Sig's (my pair are about 30" out from the rear wall), but 18" from the side walls probably isn't enough. However, most room placement guidelines recommend that speak... | |
| Right tuner for the job Thanks for the additional info. Given your present audio equipment, I'll conclude that you want to get a first-rate tuner, but are willing to buy a used unit. Have you considered getting a Sequerra tuner? They were -- and still are -- one of the f... | |
| Small diameter, flexible speaker cable under $200? I'd second the Kimber suggestion above. If you need really long runs, then the cost could go above $200, in which case I'd recommend Kimber 4VS (essentially the same cable at 4TC, except it uses a polyvinyl insulation rather than Teflon). In a boo... | |
| goldring or grado? The previous post pretty much hits the nail on the head. I had a Thorens TD-126 Mk3 back in the late 1980's (with the same tonearm you have), and used a Grado cartridge with it (can't be sure about the model, but I think it was the "MZ"). The only... | |
| Right tuner for the job Warren:Can you give us a bit more info, such as:1. Do you intend to use the tuner for critical listening, or will it be used mainly for casual listening?2. How much are you willing to spend, and are you willing to buy a used tuner?3. How good is t... | |
| Question re: "balanced" audio setup As you have probably noted from reading the posts here on A-gon, there are differing opinions about the efficacy of balanced connections in most home audio systems. It's true that balanced connections provide lower noise in systems where the inter... | |
| Lehman Black cube setting with Grado Platinum I am currently using a Grado Reference cartridge (4.5 mV output) with a Lehmann Audio Black Cube SE (which was the original version before I did the SE upgrade). The cartridge loading I use is 47 kOhms, with a 40 db gain setting (the setting speci... | |
| strange sound You may get a differing opinion from some of our technical guys, but I don't think you need to worry about the sound you hear when powering down. If you find the discharge annoying, you could replace the capacitors, but that may or may not solve t... | |
| strange sound Sounds like you have noisy power supply capacitors that are discharging slowly when you turn the amp off. | |
| Vandersteen-like "In-between" speakers The new Vandy speaker mentioned in Swklein's post above is the Vandersteen Reference Monitor that Richard V. has been working on for several years. It has been shown before at several audio shows. The speaker is essentially the top half of the Mod... | |
| Cartridge wars After trying several different cartridges with my VPI HW-19 Mk4 / Rega RB-900 (now RB-1000), I eventually chose the Grado Reference ($1200, 4.5 mV output). I have been extremely pleased with it. It is very quick (close to the best moving coils), h... |