Mike, you shouldn't be using any pressure with the Magic Eraser, you should cut a piece out and just lower the cartridge onto it and then cue it back up. No rubbing, scouring, or abrading involved.
low riding Benz Micro Gold
Hello Gentlemen,
Today I noticed that my cartridge seemed to be riding a bit low. There is only about 1/16" of space between the bottom of the cartridge and the top of record. I set it up with the Mintlp tractor, and 1.9 vtf. The cartridge has probably a little over 100 hours at the most. Is this a normal part of the break in process? I use a magic eraser to clean the stylus, could I have been using too much of an upward pressure while cleaning the stylus, or could it possibly be defective?
Thanks,
Mike
Today I noticed that my cartridge seemed to be riding a bit low. There is only about 1/16" of space between the bottom of the cartridge and the top of record. I set it up with the Mintlp tractor, and 1.9 vtf. The cartridge has probably a little over 100 hours at the most. Is this a normal part of the break in process? I use a magic eraser to clean the stylus, could I have been using too much of an upward pressure while cleaning the stylus, or could it possibly be defective?
Thanks,
Mike
9 responses Add your response