More info: I actually had a system for over a year, but it wasn't even mid-fi. I recently upgraded to the SL-3's, Stratus, and the PV-7 as well as the better cables. I do think that I'll be staying with tube preamps. Each change I made, resulted in a significant improvement. Although the overall sound seems quite good, I am sure that there is much more detail to be found. I would also like to incorporate my (currently not being used) non-powered subwoofer. I had it used previously with an active crossover, but it really did not integrate well. Is there a way to add a low pass filter to my second set of preamp outputs to extend the bass extension with the use of a addition bridged amp? I am not even familiar with what Cinepro 20 or 30 is. Is this a power conditioner? Also, is there an advantage of running second Stratus in a vertical bi-amp mode instead of mono's? There would be no cost advantage over going the mono route over vertical bi-amp mode. Any suggestions on where I can purchase Room Tunes? Also any suggestions on replacing the GCD-750 with a seperate transport and DAC? "Sound Studio Construction on a Budget" seems like a great way for me to understand the room environment issues I need to deal with.OK, I'll stop now! This discovery of how enjoyable superb sound can be is becoming a quest for me as I presume it has been for many of you. Next upgrade will certainly be the dedicated lines and a power conditioner. I do plan to proceed cautiosly. Thank you again for your advice.
improving my system, please help
I have just got a system together recently after a period of no system at all (wife factor). I currently have a CJ PV-7 pre-amp, Oddessy Stratus amp (120,000 uf upgrade), Adcom GCD-750 CD player, Martin Logan SL-3, Gronberg interconnects, Tara Labs (not sure the model) bi-wire speaker cables, isolation cones on the pre and cd player. I have no sound treatments, nor do I understand anything about them. I am on a more restrictive budget than most here on Audiogon. I am considering going to Stratus monos, upgrading to a CJ PV-5/BAT 3i or 5i/Rogue 66 or 99 and perhaps swapping out the GCD-750 for a transport/DAC setup. I am also planning on bringing in 2 dedicated lines and purchasing a HT-2000 for use with all but the amps. If I were to use the HT-2000, would I still benefit by using a dedicated line? any suggestions will be greatly appreciated.
- ...
- 16 posts total
- 16 posts total