vintage versus modern speakers


Since I have had so many excellent insights and answers to my question, here is the second chapter of my "free" education: are great vintage speakers (Infiniti, JBL,Sansui, Sony, etc..) from the seventies better sounding than what is available now? the X factor in that equation is the cost, since my speaker budget is only 1500$ for two speakers.

Ladies and Gentlemen, your advice will be read and taken into consideration.
Thank you.
rockanroller
I bought my AR9's new in 1981, and at the time the critics agreed that you could buy bigger and more expensive speakers but not better ones. And Infinities and ADS were around at the time, and the AR line-up outperformed every other speaker I heard IMO.

I was passionate over my 9's. Their dual ll" subs could blow you away; the upper bass-lower mids could send shivers down your spine; and they could talk. But the 4 ohm impedence and large woofers made them so frickin hard to drive (expensive as well). The crossovers died some time ago so then I ran the 90's--one size down. STill frickin hard to drive with my hk990 (150w/8ohms;300w/4ohms.

I picked up a pair of precursers to the the Revel line for cheap on audiogon last fall, probably the first pair of speakers Dr. Floyd Toole designed for Harman--100lb 3-way floor standers. There is no doubt that they are very clean, low distortion speakers compared with my vintage AR's.

That's my sad story. I'm transitioning to the 21st century. My stubborness had to yield to reality. No more vintage speakers for me.
You have been given good, solid advice. New speakers are definitely better, dollar for dollar, than what you'll get from 30 yr. old speakers.

And your amp now dictates the appropriate speakers to look at....

-RW-
JBL L100s have a frequency curve that looks like a smile...all highs and lows. I liked them back in the day but modern stuff is often designed with a much more even (accurate) frequency response overall, and usually far less coloration.
IMHO, the 70's not so much. But, the 80's & 90's, well that's another story.
Well, here is the amp I have: SAE 2401, SOLID STATE, NELSON PASS DESIGNED. Here are the specs:
Minimum Continuous RMS Power Per Channel (both channels driven 20 - 20,000 Hz at rated Distortion):
250 watts at 8 ohms
375 watts at 4 ohms
Total harmonic Distortion (from 250 mW to full rated power/at 1 watt): less than 0,025%/0,02%
Intermodulation Distortion (from 250 mW to full rated power): less than 0,025%
Clipping head Room: 0,5 dB
Damping Factor: 60

Frequency Response:
Rated Power : 20 Hz to 20 kHz +0, -0,5 dB
1 Watt [Normal/Hi-Pass]: 2 Hz - 160 kHz / 20 Hz - 160 kHz +0,25, -3 dB
Signal-to-Noise Ratio:
Rated Power (unweighted): 110 dB
Rated Power (IHF-a): 125 dB
1 Watt (IHF-A): 100 dB
Crosstalk (100 Hz to 10 kHz): greater than 70 dB
Rated Output : 2,24