Legacy Aeris and amplification.

Anytime! You will really appreciate what the Wavelet can do for RoomEQ; best I've ever heard for that functionality.  I used my Wavelet only for it's RoomEQ, not as a pre-amp; how will you be using it in your system?

A few tips;

- when running RoomEQ analysis, have the mic 4 foot away, aimed right at the middle of the tweeter/super-tweeter module....
- always set the DAC option to Apodizing regardless of how you utilize the unit
- after RoomEQ setup is run make sure the RoomEQ option is then to set 'On'
- Under Presets, always make sure you utilize 'Expand1'; it may seem counter-intuitive but choosing 'Linear' basically defeats the room correction bass if memory serves viz. something I was told by Legacy. Expand1 should be the default in the latest firmware but i always checked it
- I never found it necessary to alter any of the Trims, etc...for my room after RoomEQ analyzed it and computed the proper target function
- I utilized XLR inputs at all times though I've heard the other inputs and was very impressed
- I always utilized 0-trim on the dip switches in the fact; that proved to be best for my SS amp, your mileage will vary but I'd start with 0-trims and go from there....

Questions, let me know via PM or here...

Thank you Roxy...I could not agree more!

Hello - the Wavelet is connected but I can't seem to connect to bohmer for the control app. Wondering if you had the same problem and what the solution was?

Please check out the manual and follow the instructions to use a browser to get to the URL that allows you to generate a proper wifi-conf.txt file with your WiFi network parameters on it and then write it from a Windows machine to the USB memory stick they provide.  Make sure the Wavelet is fully powered down, put the USB stick in the back USB port and boot up the Wavelet and allow it a few minutes to read what's on the USB stick, configure itself to be on your network and then shut the Wavelet down complete. After that, put the WiPi wireless network USB-based adapter in the back of the Wavelet, boot it up and allow it a minute or so to connect to your wireless network. After that you'll need the serial number off the back of the Wavelet to create a URL to put in your browser with your S/N at the end of the URL. This URL then connects to the Boehmer control app, supplies your S/N to uniquely identify your unit.

This is all explained in the detail in the AERIS section of the PDF version of the manual available for download from Legacy.  

Let me know if this helps...once I got the Wavelet onto my WiFi network, I had no issue.