2. amps-preamps
  3. 129597-97719

Pass Labs XA30.5 in my system?

Dear Audiophiles!

I am looking for a solid-state class A power amplifier with balanced circuit topology to replace Acurus in my modest Hi-Fi setup:
 
Mac mini (USB3 output) ->
Singxer SU-1 ->
Yggdrasil DAC (AES/EBU XLR input) ->
Primare PRE30 preamplifier (AES/EBU XLR input) ->
Acurus A250 power amplifier (RCA input) ->
Monitor Audio RS-6
 
I am currently considering Pass Labs XA30.5 and am wondering if it will “work nicely” with my upstream and downstream components.

Any info/advice is very much appreciated. Please chime in!

Please see the specs below for your consideration.

Pass Labs XA30.5

Type: Solid-state stereo amplifier
Power Output: 30 wpc into 8 Ohm, 60 wpc into 4 Ohm (both 14.8dbW)
Power Consumption (Watts): 238
Temperature (deg C.): 53
Voltage Gain: 26 dB
Input Sensitivity: 0.77 V at 26db gain
Frequency Response: 1.5Hz–100kHz, –3db at 1.5Hz, –2db at 100kHz
Signal/noise: 150db at full power (I cannot believe this is not a misprint!)
Distortion: 0.01% at 3 watts, 0.1% at 30 watts (measured at 1 kHz)
Input Impedance: 30 kOhm balanced, 15 kOhm unbalanced
Damping Factor: 150 for an 8 Ohm nominal load
Maximum Output Current: 20 Ampere
Maximum Output Voltage: ±35 Volts
Output Noise: 150 microvolt unweighted 20 Hz - 20 kHz
DC Offset: <50 mV
Slew rate: ±50 V/µs
Dimensions: 19" (485mm) W by 7" (180mm) H by 19" (485mm) D
Weight: 62 lbs (28kg)
Shipping weight: 75 lbs (34kg)

Primare PRE30 Preamplifier

Balanced inputs          560mV
Line inputs                   280mV
Sensitivity adjustment    -20dB to +20dB
Tape outputs               280mV
Gain                            16dB
Frequency response    DC to 100kHz ± 0.1dB
THD                             <0.01%
Signal-to-noise ratio    -118dB
Crosstalk                      -113dB
Mains                            100/115/230V
Dimensions (WxDxH)    430 x 410 x 100mm
Weight                           9.5kg

Monitor Audio RS6

Frequency Response: 38 Hz - 30 KHz
Sensitivity (1W@1M):   91 dB
Nominal Impedance:     6 Ohms
Power Handling (RMS): 120 W
Recommended Amplifier Requirements (RMS): 40 - 120 W
Tweeter Crossover Frequency: 3 KHz
Drive Unit Compliment: 1 x 6” C-CAM® Bass, 1 x 6” C-CAM® Bass Mid-range. 1 x 1” gold dome C-CAM® tweeter.
Cabinet Design: Balanced velocity twin reflex ported
Product External Dimensions: (H x W x D) 850 x 185 x 250 mm
Plinth Dimensions: (H x W x D): 25 x 255 x 305 mm
Individual Weight: 18 Kg

N.B. Impedance varies with frequency and goes to as low as 4 Ohms and as high as 16 Ohms. And, most importantly,“real” sensitivity is much lower than “nominal”: 87.40dB (averaged 300Hz-3kHz, 2.83V/1m)!
Measurements taken in the anechoic chamber at Canada's National Research Council can be found through this link:
http://www.soundstagenetwork.com/index.php?option=com_content&view=article&id=1221:nrc-measu...

hardball
wolf_garcia
4,650 posts
 
Look at the tube amps for sale here on the 'Gon…simply google anything that seems interesting and there ya go! I wound up with a Jolida because I like balanced inputs (I have a balanced preamp) and the 502P had cannon plug inputs at least…not actually balanced inputs but it didn't matter after all. The new version might be actually balanced in (has a switch for that) and it allows more tube types than my amp does. Plus, even the "factory upgraded" version was relatively inexpensive, and I could talk to the Jolida dudes. My new "Fire Bottle" was stumbled into and, again, a bargain.
kdude66
1,198 posts
 
Hardball,

Another option is going with one of the recent class d amps.

I was a longtime tube and class a user for many years now I put all the heat and messing around with tubes way behind me.

Kenny.
waltersalas's avatar
waltersalas
581 posts
 

For a lot of us, once you go tubes, there is no turning back. I made the foolish mistake a couple or three years ago of getting rid of all my tube gear and buying a Devialet--which is an attractive, very "nice" sounding, user friendly, all-in-one solution--and within six months, I found I was just not listening to the music very much. As good as the Devialet was, it just did not have that tube magic. 

Bottom line, I sold it and started over, and now I am back in the tubes--and back to listening to music far too long into the night. I agree with Wolfie that the Jolida is a very nice amp. I had a 3502 for a while and really enjoyed it. Eventually I moved on to a Line Magnetic 508ia, which is the best amp I have ever owned and better than I could ever imagine an integrated sounding. The 518ia and 219ia are also excellent, and I have seen the 518 in the classifieds recently. Might be worth looking into, as most of the people who get them seem to like them as much as I do.

I am not sure what your budget is, but somewhere between Jolida, Primaluna, and Line Magnetic (just to name a few), you should be able to find something that will tickle your ears and touch your heart.

bigkidz
1,784 posts
 
If you really want the info on the amp call Peter at Pass Labs, he is a great guy.
More to discover