re capping

Digikey and Mouser are the places to get caps. Tantalum caps like to explode too, so if you're recapping a unit with those they need to go. 

@dweller A recent inquiry into the age of an amp, and my concern for the caps, resulted a response "we've tested the caps and they're all good". Is it possible to evaluate the condition of capacitors (other than working or non working)?

Because a capacitor must be removed from the circuit board (at least one end must be de-soldered and lifted) I view such claims as highly suspect. Notice that they never specifically state what tests were performed. Also, realize that an old worn capacitor may test the same as a new high-end capacitor if one is testing for capacitance value only, but the newer capacitor may sound much better.

Everything looks good and the amp sounds good but it's a 1987 and I don't know the history on it. I have a Chinese ESR meter and a regular capacitance meter and so far every cap I test has shown good. The amp has 4 36000uf 100volt caps that are too large to test on the meters I have. Is there any way that they can be tested easily? 

Absolutely replace your big caps. They are the one's that will do the most damage. You will also see smaller caps, in the range of 100uF to 1,000 uF electrolytics on each audio board. Those are also good candidates. Make sure to pay attention to the uF (same or slightly larger), V(same or larger) and temperature (higher = longer life) as wel. 

You are right, there are also 4 1700uf caps. After I replace those 8 caps should I stop there? There is no other sign problems and the amp works well. I am not trying to be cheap there's just a lot caps left.