Avoiding spade stacking is just my preference so I don't end up with bent spade connectors. If your plan is to do it once then leave it alone, stacking them should be fine. I move stuff around too much so don't like to be bothered with it. Since I make all my own wire now, I connect everything to two spades at the amp end. Just made a set of bi-wire speaker cables with 2, 9awg runs to each speaker so needed to connect 6awg of wire to a single spade at the amp end. Furez spades from Douglas Connection worked great. I used Furutech at the speaker end.
DIY Jumper Suggestions
I would like to make a DIY jumper cable for my Mirage OMD 28's. My speaker cables are NBS Omega IV which are already configured in biwire, but the OMD28's have 3 terminals on the back ("tri-wired"). Seeing that the length will be very short, I am able to go "flat out" on these jumpers ie buy some really nice wire. Does anyone have wire suggestions? I was either considering a very low gauge (8awg) silver plated military wire or something like Mundorf gold/silver wire. Any tips appreciated. Thanks.
- ...
- 20 posts total
- 20 posts total