stevea1298 I have Furman units (model unknown) but notice that the readout sometimes goes into a low voltage situation, which it is unable to regulate. Have been seriously considering a PS regenerator unit ...If your voltage is that low, I’d suggest determining the root cause of the problem. If you are in the U.S., your utility is regulated by the state, which sets the minimum performance standards under the tariff. That’s typically around 114VAC. A good start would be to measure the AC voltage at your service entrance, or close to it inside the breaker panel. That would rule out any issue between the service panel and your wall outlet. I’ve actually had this experience, and frankly utilities are not always especially responsive to low voltage issues. But it’s worth being persistent. Of course, it’s also possible that there’s something wrong with your Furman unit. You might be able to confirm that by checking voltage at the same outlet you’re using for the Furman. |
tls49, When I say I think I have a dedicated line, I asked an electrician who was working on another project for the house to install a dedicated line. The guy is a little rough around the edges and did it sort of reluctantly, so I’m not that confident in his work. I have another electrician lined up and after the suggestions here and elsewhere, the dedicated lines will be my first approach. Thanks btw, I prefer the Blue Cheer version as well. |
