2. speakers
  3. 142085-106

What is the best way to tame a slightly bright speaker?

I know the answer is get a speaker that isn't bright,  but I've got a pair of TAD Evolution Ones that I like quite a bit except that the magnesium midrange and beryllium tweeter are just a little bright for me.  I'm driving them with a D'Agostino Classic Stereo, which I needed to drive my old speakers but I don't need all that muscle for the TADs (89db sensitivity, 4 ohm impedance {doesn't drop below 4 ohms}) recommended power 50 to 250 watts. 

I'd like to get  an amp that does voices especially well.  I know somebody posted recently that a subwoofer solved his brightness problem and I may look into that at some point.  Any and all suggestions are welcome.
128x128tomcy6
motokokusanagi
65 posts
 
Toeing out sounds fine. Not to harp on this, but simple attenuation is the right solution. Looking at the crossover, a resistor change looks extremely easy to do cause it appears accessible from the base and detachable with screws.

https://static1.squarespace.com/static/55f2f41ee4b0ef7e0849e07a/t/56217563e4b0fd57269f160f/154372792...

The tweeter section is at the top and you’d want to try higher values for the series resistor (before the coil!) to the tweeter’s positive input. Mills MRA is very cheap. You could also even just use alligator clips to parallel on incremental values to the existing resistor to determine the best overall padding. http://www.sengpielaudio.com/calculator-Lpad.htm

larry5729's avatar
larry5729
65 posts
 
You might talk to Mark Kreckler at Soundings in Greenwood Village, CO.  They specialize in Master Setting speakers.  I would start there first.  They also specialize in REL subwoofers.  REL uses a different technology to create a sound stage in order to clear up high and mid frequencies.  They are not designed to produce that heart throbbing bass, but to provide greater bass extension to provide greater relaxation when listening.
dobnbav
30 posts
 
Your clear ovals May indeed be part of the problem. They are entry level Analysis Plus. Try their Oval 9’s. They remover some glare and add more robust. They should tone down your TAD’s peakyness. An inexpensive way to resolve your issue. Next, I’d by a Lyngdorf Room Correction Pre-amp and be able to create a sound curve that you like. Lastly, yes, your room is likely involved as well. Dan D’Agostino designed he-man amps before he got tossed from Krell. I haven’t heard your amp or system for that matter. You ought to consult with your dealer as he or she ought to want you Happ y with the tens of thousands you graciously spent with them.
steakster
720 posts
 
I own a Class A solid state amp - and owned Class A tube monoblocks. Love them both! But, they don’t cure brightness. Highly recommend a pair of subs - and room treatments. Just for grins - temporarily hang a large beach towel or afghan - centered on the front wall behind the speakers. It may offer a clue as to where to start. I’ve heard your speakers at several audio shows. They sound amazing.
racamuti's avatar
racamuti
257 posts
 
Hi tomcy6, Did you go to the DECWARE site and read about the ZROCK2? I really think this will fix your problem.Good luck, Tish
More to discover