Power conditioner and high end power cord

And I totally ignored the affect of power cables in my post. Why? Because no matter what the cost, no power cable will restore the needed source current the duplex outlet failed to provide at the outset. 

I guess I am one of the "others" mentioned above.

I am using a CPT 1800 with the daisy chain, cheapo switch, and breaker eliminated.
I have found that my tube mono blocks sound better plugged into the CPT 1800 rather than directly to the wall outlet.
I also have 3 dedicated 10 gauge lines with Furutech NCF outlets in the 1800 and the wall. It all matters.
But I would say, (pun intended) it is only as good as the weakest link. Including the equipment.

ozzy

Ozzy: Yes, you contributed to that discussion, and more (+1, for pointing out my memory recall issues—or my laziness to review a lot of pages devoted to modding the CPT-1800 in that thread. 😂).

Electricity is the foundation of each system. But worldwide it is still done at a very limited level. These days it becomes more often to use a separate power group. But when we talk to manufacturers it becomes clear how little they do and know about electro-smog, magnetism, and high-frequency noise.

Beside this most conditioners are very limited in the end result. When you would understand how to test a conditioner on all different aspects/properties of sound. It becomes more than clear that most conditioners are not able to reveal all the different aspects/properties of sound. This means that they will create a limitation instead of an improvement.

You can get a superior level out of a power cable when you would use a conditioner what can reveal all the aspects/properties of sound. And when you would have done a lot to limit the influence of electro-smog, magnetism, and high-frequency noise.