A Better Bluesound AC Cable?


Has anybody replaced the stock C7 IEC (Figure 8) cable on their Bluesound Node 2?
Audioquest makes an affordable 2-prong cable...
https://www.audioquest.com/cables/ac-power-cables/2-pole/nrg-1-5

And a C7 to 3-prong...
https://www.amazon.com/dp/B07DLDNDC2/ref=sspa_dk_detail_2?psc=1&smid=A17IVE6SUAZA2P

Or does it make more sense to use a C7 to standard adapter ?


128x128lowrider57
Bob, I never tried the internal DAC only because I have a very fine Audio Note plus a High Fidelity S/PDIF cable. 
Sounds wonderful with the Wireworld PC, but pretty dull and uninvolving with the stock.

Hi, I tried the nordost purpleflare, and liked it. Sound was a bit more detailed than standard.
Later on I upgraded the rest of the system to audioquest and used a audioquest z2. Sound was a little deeper and darker. I liked it better. Changes were very small.
Just picked up a new or refurbish Vault 2 directly from Bluesound and I am very pleased to say least. 

I tried it directly to my preamp with Wywires Silver IC’s and it didn’t sound too bad then with a Nordost Silver Shadow to the DAC in my CD player and pretty noticeable difference for the better.

I should have my parts today from VH Audio to build my own which I went with Furutech FI-11M and FI-8NC7, then using VH Audio Shielded Twisted Pair AC cable which I will tie the shield back at the wall. I might build the cable so I can float the shield on the fly as well. After I get some hours I will report my findings.

Also ordered a Supra CAT 8 Ethernet cable which I’ll have in a few days as well.