Is a good Cermic Cartridge an Oxymoron?


A wonderful Metzner Starlight turntable (circa 1950s) is terrible thing to waste. Yet, its induction motor throws out so much EMF that I’m afraid it’s a two-pole and therefore a death sentence for all magnetic cartridges.
While I’m going to try some heavy MuMetal application with it, I want to prepare in the event that all the transmissions can’t be shielded. Do any good ceramics carts exist?
Thanks, Mario
mario_b
Mario_b

The Micro Acoustics 830CSA wasn't Ceramic. It used capacitive elements charged by electrets (the electrostatic equivalent of permanent magnets - they hold a permanent charge. As the stylus moved one plate of a capacitor formed using the electret as the other plate, the changing capacitance with a constant charge created a voltage proportional to the movement.

This is the same principle used by high quality condenser studio mikes, though most of thee use fixed power supplies instead of electrets.

STAX also had a line of capacitive cartridges back in the 80's that I couldn't afford.

There was also at least one strain guage cartridge on the market in the early 80's as well. It too was a high priced limited availability item.

The ceramic cartride was very common in cheap department store stereos. I had one in my beadroom in 1970 and listened to lots of Led Zeppelin, Cream, King Crimson, and other new-at-the-time music.

I'm heartsick right now. I recently mounted my old Micro-Acoustic 830 CSA mounted on an Oracle Paris table in a PT6 arm, and it was sounding great. It only had about 50 hours on it. I went to dust the table and ripped the stylus cantilever off the cartridge with my polishing cloth. I didn't buy a replacement stylus in the 80's when I could, and there are none in sight now......
Tea and sympathy for Ghostrider45 -- no good deed goes unpunished, does it? : (
I am sure that every single person who has played LPs has destroyed at least one stylus in this way :-( It was my luck to do it to a MC cartridge with non-replaceable stylus.

Ain't digital great!
Throughout the 1980s I used a Jeff Rowland strain gauge board and a Panasonic strain gauge cartridge. I think I paid about $300 for the board and about $35 for cartridges and maybe $20 for stylii. I still have some of each but I sold off my Rowland board a few years ago. It was quite inexpensive relative to the performance level.
Hey Ghostrider,
Thanks for the correction on those MA carts and sorry to hear about the trashing of your stylus.
I just purchased a low end MA from the classifieds here and mounted it to test with the Metzner - No Hum whatsoever! Very good frequency range - so-so tracking - but very, very microphonic - lots of surface noise.
Was your top end MA also microphonic? Does the fixed nature of the magnets in these carts somehow make them immune to the high amount of EMF transmitted by single-pole induction motor driven tables?
Thanks, Mario