VPI table owners, help please.


I'm using the SuperScoutmaster with VPI signature arm and Dynavector XX2 or 17D3 cartridge. I'm using an Ayre P-5xe phono stage. Was wondering what cables you guys & gals have been using (or not using because?) between your arm and phonostage? I run RCA from arm to phono. Looking in the $500.00 range new for 1m pr. Any opinions would really help.
Rest of the system is VPI SDS, Ayre K-1XE preamp, Parasound JC-1 monoblocks, and Thiel CS7.2 speakers.
tom_hankins
"I dont need an actual phono cable." yes you do. It comes in rca also. The phono cables is designed to handle the special requirements of the tiny phono signal. I understand you do not need an din connector.
A purpose built phono cable has a separate ground wire for the shields at the load end to be connected to your phono pre ground terminal.This helps keep noise down by not dumping shield currents into the very low level phono signal from the cart.Also because it's NOT a line level cable and handles such a small current,many manufacturers use considerably thinner guage conductors for thier phono cables.So don't make the mistake of thinking any old 'line level' interconnect makes for a good performing phono ic.The VPI cable is relatively inexpensive and very good by the way.
I recommend Nordost Quatro Fil,almost as good as Valhalla for 1/2 the price,about 600.00 in Audiogon.
It appears that the VPI cable costs $200. Elusive Disc sells it:

http://www.elusivedisc.com/prodinfo.asp?number=HW-JMWPC

It comes in other lengths. too.