I don't have the Project, but I can tell you it's a substantial improvement on a VPI Scoutmaster.
I don't know about your isolation, but the motor should be on the same base as the table. I tried my Verus on a separate base from the Gingko the table was on, and it was obvious that wouldn't work.
Setting speeds can be a little tricky and the wording of the manual could be better, but you should be fine. Chris is very responsive to help too.
I don't know about your isolation, but the motor should be on the same base as the table. I tried my Verus on a separate base from the Gingko the table was on, and it was obvious that wouldn't work.
Setting speeds can be a little tricky and the wording of the manual could be better, but you should be fine. Chris is very responsive to help too.