SOTA Sapphire Turntable setup - how much lead?

If you have a scale, then weight the arm-board and arm. Then and enough lead to flatten the sub-plinth and then take out the amount of lead to equal the arm board and arm. Then attach the arm-board and arm and all should be well.

Signed Man of Wisdom.

This is from memory. About 6 years ago I had a Sapphire. If I am totally wrong don't slam please. My ego is very fragile.

Thanks all, especially for the generous offer of the manual. I do have the manual but it does not specify how much lead comes from the factory; it does cover the procedure. Thanks also for your input on the spikes, that seems quite logical. The footers from Mapleshade look pretty neat but pricey; any other suggestions are welcome. When I get my unit back from SOTA I will post comments on the service and also measure the leg bolts (diameter and thread). Thanks again -- hifigeezer

Since your tt is at SOTA, why not have them balance the subchassis? If you know the arm, you should be able to give them the weight. Or you could just weigh the shot you have and tell them the arm & board you are using and they can provide any additional shot you need.

For the best in sound use a reative material such as steel shot or brass. Tom

When in doubt, read the instructions! I found it in the manual, the factory supplied weight is 2 pounds 14.5 ounces. Thanks all.