You're right.
On 18/02/2010 I asked the VPI this information:
"I have a new JMW 12.6 and wanted to install in a Micro Seiki RX-1500
Please can you provide the following specifications:
Effective length
Pivot-to-spindle distance
Overhang
Offset angle
Effective mass"
Their response:
"The pivot to spindle distance is 300mm. The other parameters are not available as the computer they are on is being repaired. The alignment jig supplied with the arm will give you excellent results"
Does anyone believe this response ... I see no problem in providing this type of information ... Virtually all Tonearms manufacturers make this information available on their websites.
On 18/02/2010 I asked the VPI this information:
"I have a new JMW 12.6 and wanted to install in a Micro Seiki RX-1500
Please can you provide the following specifications:
Effective length
Pivot-to-spindle distance
Overhang
Offset angle
Effective mass"
Their response:
"The pivot to spindle distance is 300mm. The other parameters are not available as the computer they are on is being repaired. The alignment jig supplied with the arm will give you excellent results"
Does anyone believe this response ... I see no problem in providing this type of information ... Virtually all Tonearms manufacturers make this information available on their websites.