how do you determine anti-skate settings?

Re Almarg's allegation that anti-skate should not be set using a blank LP track: the frictional force that is a component of the skating phenomenon is between an offset stylus tip and a moving record surface. But he/she forgets that skating occurs on an ungrooved record too, so NO groove-wall friction is involved. And if anti-skating is properly set on an ungrooved record the L and R frictional forces that arise when a grooved record is played will be equal and opposite, and will cancel each other.
The thing that you notice when you set anti-skating with an ungrooved record is that the degree of correction depends on the radius. I usually set it for a halfway-across radius. The settings I have found for a variety of tonearms and cartridges are invariably lower than those usually recommended by manufacturers, who generally advise to dial in the tracking force. This is always too much. Rega arms for instance require about half the tracking force according to their dial calibrations.
Another misconception is that anti-skating has something to do with the behavior of a balanced tonearm floating above the surface of a record. Wrong - if the stylus is not touching the record the required friction is completely absent. The direction the floating tonearm swings has nothing to do with skating.

I'm with Almarg on this one. Is the argument by some manufacturers in favour of zero bias actually justified based on their hardware? (In some cases you see arms designed without any bias adjustment feature, the manufacture puts some positive spin on it and turns it into a selling point while avoiding a difficult engineering problem?)

Traditionally, higher VTF has always been balanced by proportionate antiskate(?) so higher VTF cannot be a solution, only make matters worse?
Personally, having watched stylii placed on blank vinyl with minimal antiskate skip towards the label at high speed whilst witnessing the kind of mistracking this produces in the RH channel if no action is taken and indeed the kind of stylus deflection that Al describes, it's hard to accept that these manufacturers are making any sense.
I can also attest to the fact that on occasions, with certain carts that are well run-in, the most subtle bias adjustments can reap considerable gains, so I'm having real difficulty suspending my disbelief.

Almarg is spot on.

Yogi, Odd, and Mac need to bone up on their physics.

check out this thread over at Vinyl Engine for some additional info and ideas

{url]http://www.vinylengine.com/phpBB2/viewtopic.php?t=27850[/url]

anyone have success with Rega arms using zero or close to it anti-skate