Solid State Pre-Amp: OK to Use With Tube Amp?


I know that the two can be used together, but would like to know what you recommend.
I have a PS Audio GCPH pre-amp and an old NAD 3155 integrated amp. The recent addition of the pre-amp has made a great improvement in the system (anyone would notice it). But if I were to upgrade the amp, which way should I go? Tube or Solid State?
I have a Clearaudio Innovation Compact TT on which a Vector 3 tonearm is presently being mounted, Mark Levison speaker wire, & Magneplanar 1 speakers.
Budget for the amp would be $1000 and used would be OK. There was a GOLDEN TUBE AUDIO GTA SE-40 TUBE AMP for sale here yesterday for $650 (or was it $850?). It's gone today, but that is the sort of tube amp in which I might be interested.
franz456
If your pre-disposed towards tubes, by all means get a tube power amplifier. But they are not "high current" devices by nature. A 60W power amp of any design, will not produce the transients and dynamics of a much higher power amp at higher sound pressure levels. And this is compounded by low impedance, low efficiency speakers. So it does get back to what types of music you listen to and the SPLs.

For an inexpensive solid state alternative with good high current output characterisitics I would consider the older Parasound amps. Not the Halo series (although they are not bad) but the earlier out of production models. Most were designed by John Curl, who also designed their much more expensive JC1 monoblock power amps.

One of the best, IMHO, is the HCA 2200ii, if you can find one. They run from about $500 to 850 used. Massive output current rating of 60 amps (90 amps surge) and this beast will drive 2 ohm loads no sweat. So the maggies are no issue. Very fast and open sounding amp.

They also made an HCA-3500 which has true dual mono power supplies and seperate amps (like two mono power amps in the same chassis), with a design similar to the 2200ii.
It has two power cords, one for each channel! 350 W/channel and a wopping 120 amps surge current capability. If you are lucky you may find this one used for under $1000.

Some believe that these earlier HCA versions rival the much more expensive JC1.

They also produced other versions of lower power ratings like the HCA-2205, HCA-1500, HCA-1000, which you can get a lot cheaper. But due to their lower power, the differences between these and a 60 W tube amp will be correspondingly less (from an output power perspective).
I had an HCA 1000A for years...bought it new actually. Great sounding amp with tons of power...input level controls, built like a tank. Sort of all the amp one needs really.

I don't think tube amps are for everyone...fiddly things really, and they're actually dying before your eyes even when working properly...but if you're into the "amp participation" thing of swapping out tubes and looking at the electron transfer glow they can be fun and sound sweet.
Having heard many an amp on Maggies, I would look to a decent 60-80W/ch or better tube amp for best sound with Magnepan. I have heard the Rogue Cronus Magnum integrated for example sound very good, especially with a nicely integrated Rel sub in the mix.

Maggies like power but are not necessarily current hungry. They can go loud but their biggest strengths relative to others are at lower to moderate listening volumes IMO.

Similar power tube amps in this range sound different from SS equivalents at higher volumes largely due to the soft clipping characteristics of most tube amps as volume goes up.